Atomstack A10 Pro Dual Laser Settings
Recommended cutting and engraving parameters for Atomstack A10 Pro using Crafteker Premium Basswood Sheets (3mm).
| Operation | Speed | Power | Passes |
|---|---|---|---|
| CUT (3mm) | 6 mm/s | 100% | 1 |
| ENGRAVE | 130 mm/s | 30% | 1 |
⚠️ Important: Laser tubes degrade over time. These settings are a starting point. ALWAYS run a small 10x10mm test cut on a corner before running your full project.