Sculpfun S9 Settings for 3mm Plywood
Recommended cutting and engraving parameters for Sculpfun S9 using Crafteker Premium Basswood Sheets (3mm).
| Operation | Speed | Power | Passes |
|---|---|---|---|
| CUT (3mm) | 3 mm/s | 100% | 2 |
| ENGRAVE | 90 mm/s | 40% | 1 |
⚠️ Important: Laser tubes degrade over time. These settings are a starting point. ALWAYS run a small 10x10mm test cut on a corner before running your full project.