xTool P2 CO2 Laser Settings for Basswood
Recommended cutting and engraving parameters for xTool P2 using Crafteker Premium Basswood Sheets (3mm).
| Operation | Speed | Power | Passes |
|---|---|---|---|
| CUT (3mm) | 25 mm/s | 60% | 1 |
| ENGRAVE | 400 mm/s | 15% | 1 |
⚠️ Important: Laser tubes degrade over time. These settings are a starting point. ALWAYS run a small 10x10mm test cut on a corner before running your full project.